772-692-5505

Shimano STEPS error codes

Shimano error E013
Drive unit firmware fault

The motor's software has a problem. A shop can reload or update it.

Checked against Shimano's own manual: October 23, 2026.

A short list, on purpose. These are the Shimano codes we could confirm in Shimano's own manuals. Most come from Shimano's Japanese manual for the E8080 system and are translated, so follow each source link for Shimano's exact wording. For any code not listed, use Shimano's official lookup at si.shimano.com/error.

What Shimano says

An abnormality was detected in the drive unit's firmware. Assist isn't available.

Shimano's recommended steps

  1. Contact the shop where you bought the bike, or a Shimano dealer.

Summarized from Shimano STEPS E8080 user manual (Japanese, translated) (error E013), checked October 23, 2026. Follow the link for Shimano's exact wording.

If it keeps coming back

If the code comes back after one restart, stop using the assist and have the bike checked by a mechanic who works on Shimano systems. Bikes Plus has diagnostic tools for Shimano and most other major motor systems.

Write down the code and what you were doing when it appeared. That saves time at the shop.

Call Bikes Plus Email a photo

Make sure it's a Shimano code

Error numbers mean different things on different systems. This page covers Shimano STEPS and EP e-bike systems. Codes starting with W are warnings, which clear when conditions improve; codes starting with E are errors, which point to a possible fault. Shimano's E-TUBE PROJECT Cyclist app can read the code from the bike.

All Shimano codes Step-by-step checks